
Custom chimney chase covers for Philadelphia-area prefab chimneys — stainless replacements for rusted covers that leak and stain siding.
If your chimney is a wood or siding chase with a metal top, that top is the chase cover — and on most prefab chimneys in the Philadelphia suburbs it is a thin galvanized pan that was always going to rust through. The signs are classic: rust streaks running down the siding, water dripping inside the chase, a cover that ponds water instead of shedding it. Left alone, the water rots the chase framing and finds the flue.
We replace chase covers with custom-measured stainless steel: the old pan comes off, the chase top and flue connections are inspected while everything is open, and the new cover is fabricated with a proper cross-break so water runs off instead of pooling, sealed at every penetration. Stainless ends the replacement cycle — it is the last chase cover the house should need.
Tell us about your chimney or gas fireplace — we confirm every request by phone. Prefer to talk? Call (855) 424-6217.
The original covers on prefab chimneys are built to a price: thin galvanized steel, flat or nearly flat, so rain sits on them in a shallow pond that finds every seam and screw hole. Galvanizing buys years, not decades. Once rust starts it perforates from the top while the underside still looks intact, which is why a chase can leak for a long time before the cover looks bad from the ground. Stainless steel with a raised cross-break solves both halves of the problem: the material does not rust through, and the shape does not hold water.
A chase often carries more than the fireplace flue: furnace and water-heater vents pass through the same cover. Each penetration gets a collar and seal in the new pan, and each vent gets checked while the top is open — it is the one moment in the chimney’s life when all of it is visible at once. If a cap or collar is at end of life, replacing it during the cover job costs a fraction of a separate roof visit.
This work is searched for by many names. Every service below is performed as part of — or booked through — this one:
Rust streaks on the siding below the chimney top, water stains on ceilings near the chimney, a drip you can hear inside the chase during rain, or visible rust on the cover itself from a ladder or drone photo. Any one of them earns an inspection.
Because the galvanized one is why you are calling us. Stainless costs more once and ends the cycle; a like-for-like galvanized replacement restarts the same clock.
Measurement happens on the inspection visit; the cover is fabricated to your chase, and installation is typically a few hours once it is on site. Total turnaround is usually measured in days, not weeks.
Coatings over perforated metal are a short reprieve at best — the rust is through, not on, the surface. If the cover is genuinely sound with surface rust only, we will say so and quote the honest option.
The cover and the cap are separate parts. If your flue cap is sound it is refitted; if it is failing, replacing it during the same visit is the economical moment, and both options are quoted before work starts.
A full sweep of the flue, firebox and smoke chamber — creosote gone, draft restored, and a written condition report before we leave.
Learn more →
Level 1 and Level 2 chimney inspections with camera scanning, a photo report and straight answers — for annual checks, home sales and after a chimney fire.
Learn more →
The annual inspection for chimneys in regular service: every accessible part checked, condition documented, safety confirmed for another season.
Learn more →
Camera inspection of the entire flue, plus attics, crawl spaces and concealed areas — the inspection for home sales, chimney fires and appliance changes.
Learn more →